This shows you the differences between two versions of the page.
en:produkte:cad_2018:layer_restaurieren [2018/02/27 13:31] (current)
|Line 1:||Line 1:|
|+||====== Layer restore ======|
|+||<WRAP round info 90%>|
|+||This command is so to speak the counterpart to [[Layer isolieren]]. After entering the command the layer state before the isolate command will be restored without further inquiries.|
|+||<WRAP round important 90%>|
|+||The command can only go one step back! \\ \\ Do not change the layer state between isolating and restoring with other commands, or else the result of Layer restore is possibly not as desired.\\ \\ Please note that you cannot isolate one layer after another without restoring them in between with the command Layer restore. Otherwise only the state of the previous isolation will be displayed. |