User Tools

Site Tools


Differences

This shows you the differences between two versions of the page.

Link to this comparison view

en:produkte:cad_2018:flaechen_3d_neigen [2018/02/27 13:31] (current)
Line 1: Line 1:
 +====== Area 3D tilt ======
  
 +<WRAP round info 60%>
 +Command: **FINCLINE**
 +</​WRAP>​
 +
 +===== Description =====
 +With this command drawing elements originating from a point are tilted in one or more directions into another plane. This function is used, for example, to generate a car park with falls and crossfalls, before it is meshed as [[Modellierung]] into a [[Triangulation]]. ​
 +
 +===== Procedure ====
 +  - After entering the command the area to be tilted needs to be selected. ​
 +  - Then, the **base point** is inquired. Here, the origin for the tilt is defined. For areas a corner point is usually suitable.\\ {{:​produkte:​cad:​dgm:​dgm0034.gif?​nolink|}}\\ \\ 
 +  - Then the following dialogue opens:\\ {{:​produkte:​cad:​dgm:​dgm0031.png?​nolink|}}\\ \\ 
 +  - With the option **[On-screen]** (Create) the direction and the length for the desired grade is specified. After executing this option the dialogue closes and the grade can be specified in the drawing.\\ Alternatively,​ also existing lines can be selected with the option **[Select]**.\\ {{:​produkte:​cad:​dgm:​dgm0035.gif?​nolink|}}\\ \\ 
 +  - One or two grades can be cosidered for the calculation of the slope.\\ {{:​produkte:​cad:​dgm:​dgm0036.gif?​nolink|}}\\ \\ 
 +  - The coordinates of the slopes are temporarily displayed in drawing and dialogue.\\ {{:​produkte:​cad:​dgm:​dgm0032.png?​nolink|}}\\ \\ 
 +  - If a slope is marked in the upper field the course of the course of the contour lines can be specified in the field **Grade**\\ The grade can be set through the definition of the parameters for **angle**, **percent** or **ratio**.\\ \\ <WRAP round tip 85%>​Positive values always denote an incline, negative a fall.\\ The command also allows for the selection of other drawing elements, not only areas.
 +</​WRAP>​ Alternatively the input can also be made **as height**. The result is listed as difference in altitude above.
 +  - After selecting the options the dialogue is confirmed with **[OK]** and the area is re-generated automatically.\\ {{:​produkte:​cad:​dgm:​dgm0033.gif?​nolink|}}