This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Previous revision
en:produkte:cad_2016:autocad_texte_drehen [2013/06/03 09:19]
en:produkte:cad_2016:autocad_texte_drehen [2020/07/20 21:01] (current)
cosmocode ↷ Links angepasst weil Seiten im Wiki verschoben wurden
Line 1: Line 1:
 +====== Rotate AutoCAD texts ======
 +<WRAP round info 60%>
 +Command: **TROTATE**
 +===== Description =====
 +With the command TROTATE texts can be rotated by simple selection and entering of the angle in the command prompt. The command is practically an extract of the command [[AutoCAD Texte bearbeiten]]. 
 +===== Procedure =====
 +  - After entering the command you are asked to select the texts from the drawing. Even if other drawing elements were selected as well, only the texts are filtered out for the amendment. Therefore, entering **ALL** is possible, also
 +  - After confirming with **<wrap caps>Enter</wrap>** or by clicking the right mouse button you are asked the specify the angle. At this, the text is changed absolutely. For this, the definition of the alignment setup with the AutoCAD command **UNITS** is gathered.
 +  - When confirmed with **<wrap caps>Enter</wrap>** or right mouse click the text will be changed.\\ \\ Initial situation\\ {{de:produkte:cad:entwurf:text002.gif?nolink|}}\\ \\ Simultaneous changes of the angle of all selected texts\\ {{de:produkte:cad:entwurf:text001.gif?nolink|}}